TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 411 of 856
CLEANING
WARNING
Cleaning solvent is TOXIC and flammable. Wear protective goggles and gloves;
use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and
do not breathe vapors. Keep away from heat or flame. Never smoke when using
cleaning solvent. Failure to comply may result in injury, illness, or death to
personnel.
Compressed air used for cleaning purposes will not exceed 30 PSI (207 kPa). Use
only with protective equipment (goggles, face shield, gloves, etc.). Failure to
comply may result in injury to personnel.
Clean oil pan with cleaning solvent and dry with compressed air.
END OF TASK
INSPECTION-ACCEPTANCE AND REJECTION CRITERIA
Inspect oil pan for holes, dents, cracks, and other damage, which may require replacement. Check for
misaligned flanges or raised surfaces surrounding bolt holes.
END OF TASK
INSTALLATION
1.
If removed, install following fittings in oil pan:
a.
For model 5063-5299: adapter (Figure 1, Item 2), two plugs (Figure 1, Item 3), plug (Figure 1, Item 4),
and plug (Figure 1, Item 13)
b.
For model 5063-5392: adapter (Figure 1, Item 11), two plugs (Figure 1, Item 6), plug
(Figure 1, Item 7), and elbow (Figure 1, Item 5)
c.
For models 5063-5393 and 5063-539L: plug (Figure 1, Item 10) and elbow (Figure 1, Item 9)
2.
Coat flange of oil pan (Figure 1, Item 1) with gasket adhesive.
3.
Place new gasket (Figure 1, Item 8) on oil pan flange with contoured end towards front of engine.
4.
Place oil pan (Figure 1, Item 1) on cylinder block with drain plug on left side. Install 22 screw and washer
assemblies (Figure 1, Item 12). Torque screw assemblies to 10–20 lb-ft (14–27 N·m) starting with center
screw on each side and working alternately toward each end of pan.
END OF TASK
END OF WORK PACKAGE
TM 9-2815-205-24
0063
0063-3/blank
Back to Top
