TM-9-2815-205-24

6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE

FEBRUARY 2013
TM-9-2815-205-24

  TM-9-2815-205-24 - Page 415 of 856

CLEANING
WARNING
Cleaning solvent is TOXIC and flammable. Wear protective goggles and gloves;
use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and
do not breathe vapors. Keep away from heat or flame. Never smoke when using
cleaning solvent. Failure to comply may result in injury, illness, or death to
personnel.
Compressed air used for cleaning purposes will not exceed 30 PSI (207 kPa). Use
only with protective equipment (goggles, face shield, gloves, etc.). Failure to
comply may result in injury to personnel.
Wash components with cleaning solvent and dry with compressed air.
END OF TASK
INSPECTION-ACCEPTANCE AND REJECTION CRITERIA
Inspect tubes, brackets, and strainer for cracks or damage.
END OF TASK
INSTALLATION
1.
Install bracket (Figure 1, Item 17), two screws (Figure 1, Item 8), eight flat washers (Figure 1, Item 9), and
two new locknuts (Figure 1, Item 16) on bracket (Figure 1, Item 10). Loosely tighten screws.
2.
Loosely install bracket (Figure 1, Item 10), two special washers (Figure 1, Item 5), two new lockwashers
(Figure 1, Item 6), and two screws (Figure 1, Item 7) on oil pump inlet tube (Figure 1, Item 1).
3.
Install strainer (Figure 1, Item 4), two flat washers (Figure 1, Item 3), and two new self-locking bolts
(Figure 1, Item 2) on inlet tube (Figure 1, Item 1). Torque bolts to 13–17 lb-ft (18–23 N·m).
4.
Install new gasket (Figure 1, Item 18), inlet tube (Figure 1, Item 1), two new lockwashers (Figure 1, Item 19),
and two bolts (Figure 1, Item 20) on lower front cover (Figure 1, Item 15). Torque bolts to 13–17 lb-ft
(18–23 N·m).
5.
Install two special washers (Figure 1, Item 13), two new lockwashers (Figure 1, Item 12), and two screws
(Figure 1, Item 11) in bracket (Figure 1, Item 17) at main bearing cap (Figure 1, Item 14). Torque screws to
30–35 lb-ft (41–47 N·m).
6.
Torque two screws (Figure 1, Item 8) to 35–39 lb-ft (47–53 N·m) and two screws (Figure 1, Item 7)
to 30–35 lb-ft (41–47 N·m), on brackets (Figure 1, Item 17 and 10).
END OF TASK
TM 9-2815-205-24
0064
0064-3


Back to Top