TM-9-2815-205-24

6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE

FEBRUARY 2013
TM-9-2815-205-24

  TM-9-2815-205-24 - Page 419 of 856

CLEANING
WARNING
Cleaning solvent is TOXIC and flammable. Wear protective goggles and gloves;
use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and
do not breathe vapors. Keep away from heat or flame. Never smoke when using
cleaning solvent. Failure to comply may result in injury, illness, or death to
personnel.
Compressed air used for cleaning purposes will not exceed 30 PSI (207 kPa). Use
only with protective equipment (goggles, face shield, gloves, etc.). Failure to
comply may result in injury to personnel.
Wash components with cleaning solvent and dry with compressed air.
END OF TASK
INSPECTION-ACCEPTANCE AND REJECTION CRITERIA
Inspect tubes, brackets, and strainer for cracks or damage.
END OF TASK
INSTALLATION
1.
Install bracket (Figure 1, Item 18), two bolts (Figure 1, Item 8), four flat washers (Figure 1, Item 9), two new
lockwashers (Figure 1, Item 17), and two nuts (Figure 1, Item 16) on bracket (Figure 1, Item 10). Do not
tighten nuts.
2.
Loosely install bracket (Figure 1, Item 10), flat washer (Figure 1, Item 5), new lockwasher (Figure 1, Item 6)
and bolt (Figure 1, Item 7) on inlet tube assembly (Figure 1, Item 1).
3.
Install strainer (Figure 1, Item 4), two new lockwashers (Figure 1, Item 3), and two bolts (Figure 1, Item 2)
on inlet tube assembly (Figure 1, Item 1). Torque bolts to 13–17 lb-ft (18–23 N·m).
4.
Install new gasket (Figure 1, Item 19), inlet tube assembly (Figure 1, Item 1), two new lockwashers
(Figure 1, Item 20), and two screws (Figure 1, Item 21) on lower front cover (Figure 1, Item 15). Loosely
tighten screws.
5.
Install two flat washers (Figure 1, Item 13), two new lockwashers (Figure 1, Item 12), and two screws
(Figure 1, Item 11) in bracket (Figure 1, Item 18) at main bearing cap (Figure 1, Item 14). Torque screws
(Figure 1, Item 11) to 30–35 lb-ft (41–47 N·m) and screws (Figure 1, Item 21) to 13–17 lb-ft (18–23 N·m).
6.
Torque bolts (Figure 1, Item 8) to 15–19 lb-ft (20–26 N·m) and bolt (Figure 1, Item 7) to 13–17 lb-ft
(18–23 N·m).
END OF TASK
TM 9-2815-205-24
0065
0065-3


Back to Top