TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 477 of 856
ASSEMBLY
NOTE
Bearing assembly (Figure 2, Item 6) will fit in pulley from either side; however, position
bearing assembly on pulley as shown for proper installation.
1.
Support pulley (Figure 2, Item 7) and press bearing assembly (Figure 2, Item 6) on pulley with shaft
extended upward. Using 1-1/4 inch (3.17 cm) diameter sleeve (Figure 2, Item 8), press outer race of bearing
until flush with inside surface of pulley.
CAUTION
Do not press bearing shaft (Figure 2, Item 2) into bearing assembly (Figure 2, Item 6).
Pressure on shaft will distort bearings and destroy bearing assembly.
NOTE
Pulley and bearing assembly will fit in bracket from either side; however, position pulley
and bearing assembly on bracket as shown.
2.
Support bracket (Figure 2, Item 4) and press bearing and pulley assembly (Figure 2, Item 9) into bracket
using 1/2 inch (1.27 cm) diameter shaft (Figure 2, Item 5). Apply pressure to shaft (Figure 2, Item 2) only.
Measure distance (Figure 2, Item A) between outer edge of pulley and bracket using thickness gage.
Distance must be 0.160 inch (0.406 cm).
8
5
9
2
A
A
4
6
7
MAINT_210
Figure 2.
Idler Pulley Assembly.
END OF TASK
FOLLOW ON TASK
Install idler pulley assembly (WP 0013).
END OF TASK
END OF WORK PACKAGE
TM 9-2815-205-24
0076
0076-3/blank
Back to Top
