TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 497 of 856
PREPARATION FOR STORAGE OR SHIPMENT
PROTECTION OF OVERHEAD ASSEMBLIES - Continued
4.
Slowly pour one-half gallon of engine oil over valves and valve train components of both cylinder heads.
5.
On model 5063-5299 install rocker arm cover (Figure 1, Item 1) and four clamp and screw assemblies
(Figure 1, Item 5) on cylinder head. Tighten clamp and screw assemblies.
6.
On models 5063-5392, 5063-5393, and 5063-539L, install rocker arm cover (Figure 2, Item 1), two resilient
mounts (Figure 2, Item 8), two flat washers (Figure 2, Item 7), and two bolts (Figure 2, Item 6) on each
cylinder head.
7.
On model 5063-5299, install hose (Figure 1, Item 4) and clamp (Figure 1, Item 3) on rocker arm cover
(Figure 1, Item 1).
END OF TASK
PROTECTION OF CRANKSHAFT
1.
Remove oil filler cap (Figure 1, Item 2).
2.
When possible, fill the crankcase with oil to approximately 15 inches (38 cm) below the top of the oil gauge
rod tube. (Used oil can be used for this purpose).
3.
Manually turn engine over at least one complete revolution.
4.
Remove oil pan drain plug and drain oil.
5.
Install oil pan drain plug.
6.
Install oil filler cap (Figure 1, Item 2).
END OF TASK
TM 9-2815-205-24
0079
0079-3
Back to Top
