TM-9-2815-205-24

6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE

FEBRUARY 2013
TM-9-2815-205-24

  TM-9-2815-205-24 - Page 744 of 856

DISASSEMBLY
1.
Remove four screws (Figure 1, Item 11) , four flat washers (Figure 1, Item 12), four copper gaskets
(Figure 1, Item 13), four air box covers (Figure 1, Item 9), four gaskets (Figure 1, Item 8), and four clamps
(Figure 1, Item 7) from cylinder block (Figure 1, Item 1). Discard gaskets.
2.
On models 5063-5393 and 5063-539L, remove transducer assembly (Figure 1, Item 10) from right front air
box cover (Figure 1, Item 9).
3.
Remove two bolts (Figure 1, Item 6), two lockwashers (Figure 1, Item 5), cover plate (Figure 1, Item 3),
draincock (Figure 1, Item 4), and gasket (Figure 1, Item 2) from right side of cylinder block.
4.
If necessary, remove four dowel pins (Figure 1, Item 23) from ends of cylinder block.
5.
Remove plug (Figure 1, Item 19), pipe plug (Figure 1, Item 17), and two pipe plugs (Figure 1, Item 22) from
right side of cylinder block. Discard plug (Figure 1, Item 19).
6.
Remove two draincocks (Figure 1, Item 18) from sides of cylinder block.
7.
Remove four pipe plugs (Figure 1, Item 20): one from left side of block, two from right side of block, and one
from top of left cylinder side.
8.
If necessary, remove four pins (Figure 1, Item 25) from rear main bearing cap (Figure 1, Item 24).
9.
Remove two expansion plugs (Figure 1, Item 26) from main oil gallery at ends of cylinder block
(Figure 1, Item 1). Discard expansion plugs.
10.
Remove expansion plug (Figure 1, Item 27) from rear of cylinder block (Figure 1, Item 1) at upper right side.
Discard expansion plug (Figure 1, Item 27).
11.
On model 5063-5299, remove two pipe plugs (Figure 1, Item 21) from dipstick holes on each side of cylinder
block (Figure 1, Item 1).
12.
On models 5063-5392, 5063-5393, and 5063-539L, remove pipe plug (Figure 1, Item 21) from dipstick hole
at left side of cylinder block.
13.
Remove pipe plug (Figure 1, Item 16) and bushing (Figure 1, Item 15) from oil gallery at right side of
cylinder block.
14.
On model 5063-5392, remove pipe plug (Figure 1, Item 14) from oil gallery at right side of cylinder block.
TM 9-2815-205-24
0098
0098-2


Back to Top