TM-9-2815-205-24

6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE

FEBRUARY 2013

TM-9-2815-205-24 - Page 746 of 856

DISASSEMBLY - Continued

15.

Remove eight camshaft bearings from cylinder block as follows:

NOTE

Camshaft bearing remover and installer set is designed for use with standard size

bearings. To remove undersized bearings, reduce outside diameter of pilot, installers,

and remover by 0.020 in. (0.51 mm).

a.

Insert small diameter end of pilot (Figure 2, Item 32) in end bearing (Figure 2, Item 31).

b.

Insert small diameter end of remover (Figure 2, Item 29) in end bearing (Figure 2, Item 28).

c.

Insert unthreaded end of shaft (Figure 2, Item 33) into pilot (Figure 2, Item 32) and through

intermediate bearings (Figure 2, Item 30). Push end of shaft into remover (Figure 2, Item 29) until shaft

snaps into place.

d.

Drive end bearing (Figure 2, Item 28) out of cylinder block.

e.

Repeat Steps 15.a.–15.d. for two intermediate bearings (Figure 2, Item 30).

f.

Insert large diameter end of pilot (Figure 2, Item 32) in camshaft end bore with bearing removed.

Repeat Steps 15.b.–15.d. to remove end bearing (Figure 2, Item 31).

g.

Repeat Steps 15.a.–15.e. for opposite cylinder side.

h.

Discard all bearings.

TM 9-2815-205-24

0098

0098-4