TM-9-2815-205-24

6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE

FEBRUARY 2013

TM-9-2815-205-24 - Page 753 of 856

ASSEMBLY - Continued

NOTE

Use J-7593-15 installer when installing right front or left rear intermediate bearing. Use

J-7593-3 installer when installing left front or right rear intermediate bearing.

e.

Slide installer (Figure 7, Item 38) on end of shaft (Figure 7, Item 33) with large diameter inserted into

end of block bore.

f.

Place spacer (Figure 7, Item 44), thrust bearing (Figure 7, Item 43), flat washer (Figure 7, Item 42),

and hex nut (Figure 7, Item 41) over threaded end of shaft (Figure 7, Item 33).

g.

Align shaft (Figure 7, Item 33) and install C-washer (Figure 7, Item 39) in groove in shaft adjacent to

installer (Figure 7, Item 40).

h.

Place C-washer (Figure 7, Item 37) in groove near end of shaft (Figure 7, Item 33).

i.

To draw bearing (Figure 7, Item 30) into position, turn hex nut (Figure 7, Item 41) until C-washer

(Figure 7, Item 37) butts up against installer (Figure 7, Item 38).

j.

Remove bearing installer (Figure 7, Item 38) assembly from cylinder block.

k.

Repeat Steps 1.a.–1.i. for remaining intermediate bearings (Figure 7, Item 30).

62°

62°

37

40

32

BEARING NOTCH ANGLE

39

33

30

41

42

43

44

38

MAINT_409

Figure 7.

Cylinder Block Assembly.

TM 9-2815-205-24

0098

0098-11