TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 756 of 856
ASSEMBLY - Continued
14.
Install new gasket (Figure 10, Item 2), cover plate (Figure 10, Item 3), two lockwashers (Figure 10, Item 5),
and two bolts (Figure 10, Item 6) on right side of block. Torque bolts to 13–17 Ib-ft (18–23 N·m).
15.
Install draincock (Figure 10, Item 4) in cover plate (Figure 10, Item 3).
NOTE
On models 5063-5393 and 5063-539L, air box cover with threaded hole must be at right
side front position and hole toward the front.
16.
Install clamp (Figure 10, Item 7), copper gasket (Figure 10, Item 13), flat washer (Figure 10, Item 12), and
screw (Figure 10, Item 11) on air box cover (Figure 10, Item 9). Install gasket (Figure 10, Item 8) on air box
cover using gasket adhesive. Turn clamp until positioned between tangs on back of air box cover. Insert four
air box cover assemblies into cylinder block, place clamp against inner cylinder block wall, and tighten
screws to 12–15 Ib-ft (16–20 N·m).
17.
On models 5063-5393 and 5063-539L, install transducer assembly (Figure 10, Item 10) in right front air box
cover (Figure 10, Item 9).
1
FRONT
* MODELS 5063-5393, 5063-539L
7
2
3
4
8
9
13
12
11
*10
5
6
MAINT_412
Figure 10.
Cylinder Block Air Box Cover Installation.
END OF TASK
TM 9-2815-205-24
0098
0098-14
Back to Top
