TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 758 of 856
8.
Immerse cylinder block in water heated to 180–200°F (82–93°C) for 20 minutes.
WARNING
Wear eye protection when working with pressurized air system. Make certain air pressure
is fully vented before disassembly. Sudden release of air pressure can throw debris.
Failure to comply may result in injury to personnel.
9.
Apply 40 psi (276 kPa) air pressure to water jacket and observe water in tank for bubbles which indicates a
crack or leak in block. Replace block if cracked.
10.
After completing pressure test, release air pressure and remove block from water tank. Remove plates,
seals, liners, and gaskets from cylinder block.
WARNING
Compressed air used for cleaning purposes will not exceed 30 PSI (207 kPa). Use only
with protective equipment (goggles, face shield, gloves, etc.). Failure to comply may result
in injury to personnel.
11.
Blowout all passages in block with compressed air.
12.
Dry cylinder liners with compressed air and coat with lubricating oil to prevent rust from forming.
END OF TASK
FOLLOW ON TASK
1.
Install crankshaft (WP 0097).
2.
Install cylinder liners (WP 0097).
3.
Install cylinder kits (models 5063-5392, 5063-5393, and 5063-539L) (WP 0095).
4.
Install cylinder kits (model 5063-5299) (WP 0094).
END OF TASK
END OF WORK PACKAGE
TM 9-2815-205-24
0098
0098-16
Back to Top
