TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 757 of 856
TEST AND INSPECTION
NOTE
Ensure all water hole plugs are in cylinder block before pressure testing.
1.
Install two preformed packings (Figure 11, Item 51) in grooves at each cylinder bore position.
2.
Apply shortening compound or antifreeze to inner surface of preformed packings (Figure 11, Item 51).
3.
Slide cylinder liners (Figure 11, Item 50) into block, being careful not to roll or damage preformed packings
(Figure 11, Item 51).
4.
Install three compression gaskets (Figure 11, Item 49), four large seal rings (Figure 11, Item 54), and four
small seal rings (Figure 11, Item 52) on top surface of each cylinder side.
5.
Install fabricated blocking plate (Figure 11, Item 46), eight flat washers (Figure 11, Item 47), and eight bolts
(Figure 11, Item 48) on top of each cylinder side. Tighten bolts securely.
6.
Install gasket (Figure 11, Item 2), water hole cover (Figure 11, Item 3), two lockwashers (Figure 11, Item 5),
and two bolts (Figure 11, Item 6) on each side of cylinder block. Plug hole in one of the covers with 1/8 inch
NPTF pipe plug (Figure 11, Item 53).
7.
Connect air line with regulator to hole in other water hole cover (Figure 11, Item 3).
46
48
47
52
51
50
49
52
54
54
52
53
3
2
5
6
MAINT_413
Figure 11.
Cylinder Liner Installation.
TM 9-2815-205-24
0098
0098-15
Back to Top
