TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 510 of 596

TM 9-2815-205-34

4-5. CYLINDER COMPRESSION TEST (Cont)

j.

k.

l.

Loosen locknut (12) and back out adjusting

screw (13) on control tube lever (14). Slide

injector control lever on injector control tube

(15) away from injector control rack (16).

Remove bolt (17), convex washer (18), clamp

(19), and injector (20) in cylinder head.

CAUTION

Injector clamp must not inter-

fere with follower spring or

exhaust valve springs when

installed, Damage could occur

to engine valve or injector

clamp.

Install cylinder adapter (21), clamp (19),

convex washer (18), and bolt (17) in injector

tube. Torque bolt to 20-25 lb-ft (27-34 N-m).

Connect cylinder tester (22) to adapter.

CAUTION

Exhaust valve bridges must

rest on ends of exhaust valves

when tightening rocker arm

shaft bolts or damage to

exhaust valves will result.

m. Position rocker arms (10) over pressure gage and adapter (21), and exhaust valves. Install two

rocker arm shaft bolts (8) and torque to 50-55 Ib-ft (68-75 N-m).

NOTE

.

Do not crank engine using starter motor to obtain compression pressure. Engine must

be running to obtain accurate reading.

. Variation in compression pressures between cylinders must not exceed 25 PSI (172

kPa) at 600 RPM.

. Use spare fuel tube to fabricate a jumper connection between fuel inlet and fuel return

manifold connectors. Do not install fuel tubes on engine after bending for fabrication.

n. Install spare fuel tube (23) between inlet manifold (24) and return manifold (25).

4-26