TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 207 of 968

TM 9-2815-210-34-2-2

d .

Assembly.

NOTE

If working on engine LDS-465-2, go to frame 3.

Put a light coat of lubricating oil on shafts and

on all bushings in pressure pump.

FRAME 1

1

0

Put a light coat of lubricating oil on shafts (1 and 2) and on bushing (3).

2.

Put square key (4) in slot of drive impeller shaft (2).

3.

Put drive impeller shaft (2) in pressure pump housing (5) as shown.

Threaded end of drive impeller shaft should fit through bushing (3) in

drive impeller housing.

4.

Slide pressure pump driven impeller (6) over driven impeller shaft (1) and

into pressure pump housing (5) as shown.

GO TO FRAME 2

4-188