TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 209 of 968

TM 9-2815-210-34-2-2

FRAME 3

1.

Put a light coat of lubricating oil on shafts (1, 2, and 3) and in all bushings

in pressure pump housing (4), bushing in driven impeller (5), and bushing

in scavenge pump housing (6).

2.

Slide pressure pump driven impeller (5) over driven impeller shaft (1) and

into pressure pump housing (4) as shown.

NOTE

Drive impeller and drive impeller shaft (2) do not come

apart from scavenge pump housing (6).

3.

Put scavenge pump housing (6) on pressure pump housing (4) so that

threaded end of drive impeller shaft (2) fits through bushing (7).

4.

Slide scavenge pump drive impeller (8) over driven impeller shaft (1) and

into scavenge pump housing (6) as shown.

GO TO FRAME 4

4-190