TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 372 of 968

TM 9-2815-210-34-2-2

b. Engine LDS-465-2.

(1) Cleaning.

FRAME 1

1.

2.

3.

Take off four clamps (1).

Clean inside and outside of three tubes (2, 3, and 4) with soapy water and

dry with clean cloth.

WARNING

Dry cleaning solvent is flammable. Do not use near

an open flame.

Keep a fire extinguisher nearby when

solvent is used.

Use only in well-ventilated places.

Failure to do this may result in injury to personnel

and damage to equipment.

CAUTION

Do not let dry cleaning solvent touch three tubes

(2, 3, and 4).

Tubes will dry out, rot, and need

replacement.

If dry cleaning solvent splashes on

tubes, dry off with clean cloth.

Clean four clamps (1), four screws (5), and six tube nuts (6) with dry

cleaning solvent.

Use a stiff brush to take off sludge or gum deposits.

Dry with clean cloth.

END OF TASK

4-353