TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 374 of 968

TM 9-2815-210-34-2-2

c .

Engines LD-465-1, LD-465-1C, LDT-465-1C, and LDS-465-1A.

(1) Cleaning .

FRAME 1

1.

2.

3.

Take off two clamps (1).

Clean inside and outside of three tubes (2, 3, and 4) with soap and water and

dry with clean cloth.

WARNING

Dry cleaning solvent is flammable. Do not use near

an open flame.

Keep a fire extinguisher nearby when

solvent is used.

Use only in well-ventilated places.

Failure to do this may result in injury to personnel

and damage to equipment.

CAUTION

Do not let dry cleaning solvent touch three tubes

(2, 3, and 4).

Tubes will dry out, rot, and need

replacement.

If dry cleaning solvent splashes on

tubes, dry them with clean cloth.

Clean two clamps (1), two screws (5), and six tube nuts (6) with dry cleaning

solvent.

Use a stiff brush to take off sludge or gum deposits. Dry with clean

cloth.

END OF TASK

4-355