TM-9-2815-210-34-2-2
ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2
APRIL 1981
TM-9-2815-210-34-2-2 - Page 380 of 968
TM 9-2815-210-34-2-2
(2) Cleaning.
FRAME 1
1.
2.
WARNING
Dry cleaning solvent is flammable. Do not use near an
open flame.
Keep a fire extinguisher nearby when solvent
is used.
Use only in well-ventilated places. Failure to do
this may result in injury to personnel and damage to
equipment.
CAUTION
Do not put hydraulic pump (1) in dry cleaning solvent.
Parts can be damaged and pump will not run properly.
Clean hydraulic pump (1) with dry cleaning solvent. Use a stiff brush to
take off carbon and sludge. Dry with clean cloth.
Clean adapter (2), drive gear (3), manifold assembly (4), elbow (5), three
screws (6), nut (7), woodruff key (8), and two nuts (9) in dry cleaning
solvent.
Use stiff brush to remove carbon and sludge. Dry with clean
cloth.
END OF TASK
4-361
Back to Top
