TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

  TM-9-2815-210-34-2-2 - Page 512 of 968

TM 9-2815-210-34-2-2
FRAME 2
WARNING
1.
2.
Dry cleaning solvent is flammable. Do not use near an
open flame.
Keep a fire extinguisher nearby when sol-
vent is used.
Use only in well-ventilated places.
Failure to do this may result in injury to personnel and
damage to equipment.
CAUTION
Do not let dry cleaning solvent touch hydraulic pump
return hose (1), bypass hose (2) or supply hose (3).
Hoses will dry out and crack. If dry cleaning solvent
splashes on hoses, dry with clean cloth.
Clean supply hose fittings (4) with a cloth soaked with dry cleaning solvent.
Clean off sludge and gum with a stiff brush. Dry with clean cloth.
Clean two screws (5), two nuts (6), two lockwashers (7), four loop clamps
(8), and four hose clamps (9) with dry cleaning solvent. Clean off sludge and
gum with a stiff brush. Dry with clean cloth.
END OF TASK
4-493


Back to Top