TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 807 of 968

TM 9-2815-210-34-2-2

FRAME 7

Soldier A

1.

Check whether there is a captive screw (1) in bottom mounting

hole of fuel pump (2).

2.

Check whether there is a fuel pump mounting stud (3) on engine.

3.

If fuel pump (2) has captive screw (1) and engine has fuel pump

mounting stud (3), take out mounting stud.

NOTE

New or rebuilt fuel pumps (2) come with new preformed

packing (4).

4.

If fuel pump (2) does not have preformed packing (4), put it on.

NOTE

If mounting stud (3) was taken out and thrown away, go

to frame 9.

5.

If fuel pump (2) does not have captive screw (1) and engine has

fuel pum

p

mounting stud (3), slide pump over mounting stud and

hold it against mounting adapter (5). Mounting stud should fit

through bottom mounting hole on fuel pump. Mounting holes (6)

on pump should line up with mounting holes (7) on mounting adap-

ter.

GO TO FRAME 8

5-178