TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 815 of 968

TM 9-2815-210-34-2-2

FRAME 1 5

1.

2.

3.

4.

5.

6.

Turn crankshaft about 45° to the left as viewed from front of engine. Then

turn crankshaft back to the right until proper timing mark on crankshaft

vibration damper and pulley lines up with timing pointer on timing gear cover.

Refer to frame 1.

Check fuel injection pump timing again. Refer to frames 13 and 14.

Put automatic timing device cover gasket (1) on automatic timing device win-

dow (2) as shown. Put automatic timing device cover (3) on automatic timing

device window as shown.

Screw in and tighten four screws and lockwashers

(4) .

Put timing window gasket (5) on side of fuel pump (6) as shown.

If working on any engine except LDS-465-2, put timing window cover (7) on

side of fuel pump (6) as shown.

Put in two fillister head screws and lock-

washers (8).

If working on engine LDS-465-2, put fuel shutoff solenoid (9) on side of fuel

pump (6).

Put in two sockethead

-

screws and lockwashers (10).

END OF TASK

5-186