TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 820 of 968

TM 9-2815-210-34-2-2

b .

Injector Tube Clamp.

FRAME 1

NOTE

Some engines have six tube clamps and some have two

tube clamps.

This task is shown for engines with six

tube clamps.

Two screws (1) were put back after tubes

were taken out.

1.

Take out two screws with flat washers (1). Put two brackets (2) in placse.

Put in two screws with flat washers.

NOTE

Some engines do not have bracket (3).

2. Put bracket (3) in place. Put in screw with lockwasher (4). Put clamp (5)

in place.

Put in two screws with flat washers and locknuts (6).

FOR ALL ENGINES EXCEPT LDS-465-2, GO TO FRAME 2.

FOR ENGINE LDS-465-2, GO TO FRAME 3

5-191