TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 811 of 968

TM 9-2815-210-34-2-2

FRAME 11

1.

2.

3.

GO

Hold fuel

NOTE

Do not turn fuel pump drive gear hub (1) when

putting on fuel pump drive gear (2) and fuel pump

drive gear retaining plate (3).

pump drive gear (2), on drive gear hub (1). Screw holes (4) in

drive gear hub should-be at left end of elongated holes in fuel pump

-

d-rive

gear (2) as shown.

Fuel pump drive gear must mate with camshaft gear (5)

as shown.

Hold fuel pump drive gear retaining plate (3) against fuel pump drive gear (2),

Holes in retaining plate must line up with screw holes (4) in fuel pump drive

gear hub (1).

Put in but do not tighten three screws and lockwashers (6) to hold retaining

plate (3) and fuel pump drive gear (2) in place.

TO FRAME 12

5-182