TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 823 of 968

TM 9-2815-210-34-2-2

5-36. TURBOCHARGER ASSEMBLY.

a.

Engine LDT-465-1C.

FRAME 1

1.

2.

3.

4.

Put fuel

Put fuel

CAUTION

Do not use open end wrench to put flame heater fuel

inlet adapter (1) or flame heater fuel return adapter

(2) into nozzle and check valve assembly (3). Adap-

ters may be damaged.

Use only tubing wrench or box

wrench.

inlet adapter (1) into nozzle and check valve assembly (3).

return adapter (2) into nozzle and check valve assembly (3).

NOTE

Make sure that locknut (4) is put onto nozzle and check

valve assembly (3) before nozzle and check valve assem-

bly is put into intake manifold elbow (5).

Hand tighten nozzle and check valve assembly (3) into intake manifold elbow

(5). Tighten locknut (4) against intake manifold elbow. Adapters (1 and 2)

should face as shown.

Put spark plug gasket (6) over end of spark plug (7) as shown. Put in

spark plug.

NOTE

Make sure that hose (8) is on end of intake elbow (5)

and that both hose clamps (9) are on hose.

GO TO FRAME 2

5-194