TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 824 of 968

TM 9-2815-210-34-2-2

Soldier A

Soldier B

1.

2.

3.

4.

Put turbocharger-to-exhaust manifold gasket (1) on mounting

flange of turbocharger (2). Holes in gasket must line up with

holes in turbocharger mounting flange.

Hold mounting flange of turbocharger (2) against exhaust manifold

flange (3). Two studs (4) in exhaust manifold flange must fix

through holes in turbocharger-to-exhaust manifold gasket (1) and

turbocharger mounting flange.

Put in two screws (5) and locknuts (6). put locknut (7) on each

of two studs (4).

NOTE

Make sure that hose clamp (8) is loose.

Push crankcase breather tube (9) into breather tube adapter

hose (10).

Breather tube must fit between front and rear halves

of turbocharger (2) as shown. Tighten hose clamp (8).

GO TO FRAME 3

5-195