TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 825 of 968

TM 9-2815-210-34-2-2

1.

2.

3.

4.

5.

6.

7.

8.

GO

Put in oil drain hose adapter (1).

Put oil drain gasket (2) on turbocharger oil drain mounting flange (3).

NOTE

Make sure that two hose clamps (4) are on oil drain hose (5).

Hose clamps should be loose and near center of drain hose

as shown.

Slide oil drain hose (5) onto end of oil drain tube (6).

Lift breather tube and bracket (7) up and out of the way of turbocharger oil

drain mounting flange (3).

Slide oil drain hose (5) over oil drain hose adapter (1). Hold oil drain tube

flange (8) against turbocharger oil drain mounting flange (3) so that mount-

ing holes line up.

Let breather tube and bracket (7) down so that bracket rests on oil drain

tube flange (8).

Hole in bracket should line up with hole in oil drain tube

flange.

Put in two screws (9) and lockwashers (10).

Slide two hose clamps (4) to ends of oil drain hose (5) and tighten clamps.

TO FRAME 4

5-196