TM-9-2815-225-34-P

ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JULY 2005

TM-9-2815-225-34-P - Page 152 of 736

TM 9-2815-225-34&P

0011 00

0011 00-6

CYLINDER HEAD AND CYLINDER HEAD COMPONENTS REMOVAL (Contd)

CYLINDER HEAD

1.

Scribe a locating mark (6) on cylinder head (7) and cylinder block (8) before removal.

NOTE

Perform step 2 if removing front and rear cylinder head.

2.

Remove four screws (3), fuel crossover connection (2), and four O-rings (1) from cylinder head (7).

Discard O-rings (1).

NOTE

Perform step 3 if removing center cylinder head.

3.

Remove eight screws (3), two fuel crossover connections (2), and eight O-rings (1) from center

cylinder head (7). Discard O-rings (1).

4.

Remove twelve bolts (5) and washers (4) in sequence (9) securing cylinder head (7) to cylinder

block (8).

5.

Remove cylinder head (7) and gasket (10) from cylinder block (8). Discard gasket (10).

6.

Repeat steps 1 through 5 for remaining cylinder heads (7).

7.

For cylinder head repair (7), refer to WP 0014 00.

Figure 5.

Cylinder Head Removal.

END OF WORK PACKAGE

1

2

3

4

5

8

7

9

8

7

6

10

~