TM-9-2815-225-34-P

ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JULY 2005

TM-9-2815-225-34-P - Page 159 of 736

TM 9-2815-225-34&P

0012 00

0012 00-7

CYLINDER BLOCK COMPONENTS REMOVAL (Contd)

Figure 6. Camshaft and Camshaft Followers Removal.

CAMSHAFT FOLLOWERS

NOTE

Scribe locating mark on cam follower and cylinder block before

removal.

1.

Remove six screws (13) and lockwashers (14) from cam follower (12). Discard lockwashers (14).

2.

Remove cam follower (12), and gasket (11) from cylinder block (10).

NOTE

Measuring thickness of gasket for each cam follower is required

for correct timing of injectors due to individual differences

between castings.

3.

Using a micrometer, measure gasket (11) at three points (A), (B), and (C) and record average

thickness. Discard gasket (11) when all measurements have been taken and recorded.

4.

Repeat steps 1 through 3 to remove remaining cam followers (12).

CAUTION

Use extreme care when removing camshaft or damage to

camshaft bushings may occur.

5.

Install four camshaft pilot tools on front of camshaft (9).

6.

Using camshaft pilot tools, slowly turn camshaft (9) and remove camshaft (9) from cylinder block

(10).

7.

Remove camshaft pilot tools from camshaft (9).

8.

For camshaft repair, refer to WP 0019 00.

9

10

11

12

14

13

B

C

A