TM-9-2815-225-34-P
ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2005
TM-9-2815-225-34-P - Page 156 of 736
Figure 3. Oil Pan Removal.
TM 9-2815-225-34&P
0012 00
0012 00-4
CYLINDER BLOCK COMPONENTS REMOVAL (Contd)
OIL PAN
NOTE
Removal procedures are the same for Big Cam I and Big Cam III.
Both oil pans are shown in Figure 3.
Rotate engine on maintenance stand so the oil pan is facing up.
1.
Remove four bolts (10) and engine shipping support (9) from oil pan (4).
2.
Remove four bolts (7), lockwashers (6), and washers (5) from rear of oil pan (4). Discard
lockwashers (6).
3.
Remove twenty-eight bolts (8), oil pan (4), and gasket (3) from cylinder block (2). Discard gasket (3).
4.
Remove four bolts (12) securing front of oil pan (1) to cylinder block (2).
5.
Remove four bolts (7), lockwashers (6), and washers (5) from rear of oil pan (1). Discard
lockwashers (6).
6.
Remove twenty-eight bolts (11), oil pan (1), and gasket (3) from cylinder block (2). Discard
gasket (3).
7.
For oil pan repair, refer to WP 0022 00.
BIG CAM I
BIG CAM III
3
5
6
7
4
8
10
9
11
12
1
2
2
Back to Top
