TM-9-2815-225-34-P

ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JULY 2005

TM-9-2815-225-34-P - Page 157 of 736

TM 9-2815-225-34&P

0012 00

0012 00-5

CYLINDER BLOCK COMPONENTS REMOVAL (Contd)

Figure 4. Front Gear Cover Removal.

FRONT GEAR COVER

1.

Remove six short bolts (13) and washers (14) from front engine support (15).

2.

Remove two long bolts (27), washers (28), and front engine support (15) from front gear cover (23).

NOTE

Perform steps 3 and 4 for Big Cam I engine.

3.

Remove three screws (16), lockwashers (29), washers (30), camshaft support (17), shim pack (18),

and O-ring (19) from front gear cover (23). Discard O-ring (19) and lockwashers (29).

4.

Remove two screws (20), lockwashers (21), and washers (22) from front gear cover (23). Discard

lockwashers (21).

NOTE

Perform steps 5 and 6 for Big Cam III engine.

5.

Remove three captive washer screws (16), camshaft support (17), shim pack (18), and O-ring (19)

from front gear cover (23). Discard O-ring (19).

6.

Remove two captive washer screws (20) from front gear cover (23).

7.

Remove nine captive washer screws (26) and one captive washer screw (25) from front gear cover (23).

8.

Remove front gear cover (23) and gasket (24) from cylinder block (2). Discard gasket (24).

25

14

13

27

28

13

14

15

20

26

30

29

16

23

24

2

22

21

19

18

17