TM-9-2910-226-34

PUMP, FUEL, METERING AND DISTRIBUTING, ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT, MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

JUNE 1974

TM-9-2910-226-34 - Page 101 of 208

TM 9-2910-226-34

Figure 3-83. Installing high speed and idle adjustment screws.

(17) Refer to figure 3-59 and install dust cover

(D), lockwasher (C) and machine bolt (B). Torque

tighten dust cover bolt to 50-60 inch-pounds. Do not

install lead seal safety wire at this time.

(18) Refer to figure 3-84. Insert a feeler gage (A)

to obtain a clearance of 0.002 to 0.004 inch between

the operating lever and dust cover. Loosen clamping

screw (B), lockwasher (C), and nut (D). Move lever

as necessary to obtain this clearance. Torque tighten

nut to 70-75 inch-pounds.

Figure 3-84. Checking operating lever clearance using a feeler gage

NOTE

Sub-paragraph (19) below applies to code A

pumps only.

(19) Refer to (16) above and figure 3-83 and

install idle and high speed adjusting screws. Refer to

figure 3-85. The operating lever and stop lever is one

piece on this pump. Install screw (A), lockwasher (B)

and nut (C). Install operating lever assembly in up

position on operating shaft (D) with the split in lever

alined with scribe mark on end of operating shaft