TM-9-2910-226-34
PUMP, FUEL, METERING AND DISTRIBUTING, ASSEMBLY
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT, MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS
JUNE 1974
TM-9-2910-226-34 - Page 96 of 208
TM 9-2910-226-34
Install cotter pin from bottom and spread prongs
tightly around the rod pin screw.
NOTE
After assembly, place fulcrum lever in
vertical position. Raise fuel control rod to a
horizontal position. When free, fuel control
rod should drop slowly of its own weight.
NOTE
Paragraphs (4), (5) and (6) do not apply to
code A injection pumps.
(4) Refer to figure 3-74 and install fulcrum lever
assembly in governor housing. Fulcrum lever pivot
pins must have a dimension (X) (fig. 3-67) of 0.165.
Figure 3-73. Adjusting smoke limit cam angle.
Figure 3-74. Installing fulcrum lever and associated-sin
governor housing.
3-50
Back to Top
