TM-9-2920-257-30-P
GENERATOR, ALTERNATING CURRENT, 200 AMPERES
TECHNICAL MANUAL; DIRECT SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS
MAY 1987
TM-9-2920-257-30-P - Page 47 of 111
TM 9-2920-257-30&P
NOTE
While applying grease, use finger to form the seal lips of inside
seal as shown in figure 3-8.
(d) Apply thin film of grease (item 4, App B) t
O
li p
S
of insid e
seal .
(3) Install stator to drive end housing assembly (fig. 3-1).
NOTE
Aline locator pin in drive end housing assembly with matching
hole in stator .
(a) Place stator (19) in anti-drive end housing (9) so that
stator laminations fit flush in pilot bore of anti-drive end housing
protect stator windings.
(b) Place terminal block insulator (20) onto stator terminal studs
so that hex cavities of insulator fit over hex portions of studs.
NOTE
Aline stator locator pin with matching hole in drive end
housing.
(c) Place drive end housing assembly (21) over stator (19) so that
three stator terminal studs pass through three holes in housing and
stator locator pin meshes with matching hole in drive end housing
assembly.
3-1 7
to
Back to Top
