TM-9-2920-257-30-P
GENERATOR, ALTERNATING CURRENT, 200 AMPERES
TECHNICAL MANUAL; DIRECT SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS
MAY 1987
TM-9-2920-257-30-P - Page 48 of 111
TM 9-2920-257-30&P
CAUTION
Insulator can crack if not properly alined in depression in
drive end housing assembly.
Carefully aline insulator in
depression.
(d) place insulator (18) over stator terminal studs in drive
end housing assembly (21) and secure with six spring washers (17),
three flat washers (16), and nuts (15).
Torque nuts to 16-18
pound-feet.
(e) Refer to figure 3-10 and connect three negative rectifier
leads and three positive rectifier leads to stator terminal studs as
follows :
1
.
Assemble negative rectifier leads (1, 2, and 3) to stator
studs in that order,
and secure with three nuts (15).
Torque nuts
to 12-14 pound-feet.
2 .
Assemble positive rectifier leads (4, 5, and 6) to stator
terminal studs.
Nuts will be installed in step (10)(e) 2 below.
(f) Remove stator (19) and drive end housing assembly (21)
from anti-drive end housing (9) and place it on workbench with
stator facing up.
(4) Install roller bearing to anti-drive end housing (fig. 3-1) .
(a) Place anti-drive end housing (9) in arbor press with
exterior of housing facing up.
(b) Place roller bearing (12) in position on bearing bore with
lettered end of bearing facing up.
3-1 8
Back to Top
