TM-9-2920-257-30-P
GENERATOR, ALTERNATING CURRENT, 200 AMPERES
TECHNICAL MANUAL; DIRECT SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS
MAY 1987
TM-9-2920-257-30-P - Page 56 of 111
TM 9-2920-257-30&P
NOTE
Have helper assist in steps (d) and (e) below.
(d) Install combined circuit panel assembly unit (11) and brus h
assembly unit (12) in drive end housing assembly (6). Tighten four
screws (1).
(e) Install leads as follows ,
using figure 3-10 as a guide for
making lead connections.
1 .
Secure short black lead from printed circuit panel assembly
(5) to housing ground hole in drive end housing assembly (6) using screw
(11, fig. 3-2) .
Tighten screw securely.
2 .
Secure each of the three long black leads from printed
circuit panel assembly (5) to each of the three stator terminal studs
using three nuts (10, fig. 3-2) .
Route leads in cavity of drive end
housing assembly (6) along with negative rectifier leads.
Torque nuts to
12-14 pound-feet.
(11) Install mounting plate and connector assembly to drive end
housing assembly (fig. 3-2).
Use figure 3-2 and figure 3-12 to make lead
connections.
(a) Route two heavy black connector leads through brush holder
cavity in drive end housing assembly (6) to positive rectifier area of
drive end housing assembly.
(b) Secure three thin black connector leads and two black brush
leads to printed circuit panel assembly (7) using three screws (8) and
lock washers (9).
Tighten screws securely.
(c) Secure connector assembly (4) and mounting plate (5) on drive
end housing assembly (6) using four screws (2) and lock washers (3).
Tighten screws securely.
3-2 6
Back to Top
