TM-9-2920-257-30-P
GENERATOR, ALTERNATING CURRENT, 200 AMPERES
TECHNICAL MANUAL; DIRECT SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS
MAY 1987
TM-9-2920-257-30-P - Page 62 of 111
TM 9-2920-257-30&P
(7.) Using a puller (item 7, App D.), remove rear bearing (15) from core and shaft.
(8.)
Remove six flange nuts (13) from core and shaft studs.
(9.) Use three 10-32 UNF X 2 inch long machine screw as jackscrews.
Install three screws in threaded holes of
rotor end plate.
Pull rotor from core by gradually working screws against core in sequence.
3-32
Change 1
Back to Top
