TM-9-2920-257-30-P
GENERATOR, ALTERNATING CURRENT, 200 AMPERES
TECHNICAL MANUAL; DIRECT SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS
MAY 1987
TM-9-2920-257-30-P - Page 57 of 111
TM 9-2920-257-30&P
CAUTION
Care must be taken to ensure terminals do not touch any portion
of drive end housing assembly.
Failure to do so will result in
damage to equipment.
(d) Secure two heavy black connector leads and one thin red lead
from printed circuit panel assembly (7) to Positive rectifier heat sink
using two brass bolts (1).
Tighten bolts securely.
(12) Install cover plate on drive end housing assembly (fig. 3-1).
NOTE
When assembling cover plate, use black paint outline and scribe
marks on drive end housing assembly as a guide to ensure proper
orientation of cover on housing.
(a) Install cover plate (6) on front face of drive end
housing assembly (21) using six screws (4) and eight
S C
r e
WS
(5) .
(b) Tighten screws securely.
(13) Install fan (fig. 3-1) .
(a) Install key (3) in key slot of shaft of rotor (14) .
(b) Clamp pulley end of shaft of rotor (14), with key (3)
inserted in key-slot, in vise with soft-jaw caps to keep generator
shaft from turning.
3-2 7
Back to Top
