TM-9-2920-257-30-P
GENERATOR, ALTERNATING CURRENT, 200 AMPERES
TECHNICAL MANUAL; DIRECT SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS
MAY 1987
TM-9-2920-257-30-P - Page 53 of 111
TM 9-2920-257-30&P
(d) Press inside seal (10) into seal bore until it is flush with
face of anti-drive end housing (9).
(e) Turn anti-drive end housing (9) over in arbor press.
NOTE
Outer seal in anti-drive end housing is to be assembled so
that seal lips flare outward, away from rotor.
(f) Apply thin film of grease (item4, App B) to lips o f
outer seal (11).
Place outer seal in position on the seal bore of
anti-drive end housing (9) with seal lips flaring outward, away from
rotor (14) .
See figure 3-8 for proper seal lip position.
(g) Press outer seal (11) into seal bore until it is flush
with face of anti-drive end housing (9).
(8) Install slideable bushing in anti-drive end housing ear
(fig.3-1) .
(a) Place anti-drive end housing (9) in arbor press so that
inner side of anti-drive end housing (side nearest rotor (14)) faces
up.
Housing ear must be supported.
(b) Press slideable bushing (13) into ear on anti-drive end
housing (9) until flush .
(9) Install anti-drive end housing on drive end housing
assembly (fig. 3-1).
(a) Slide anti-drive end housing (9) on shaft of rotor (14).
(b) Push anti-drive end housing (9) tightly against stator (19)
making sure that stator locator pin meshes with matching hole in
anti - drive
end housing.
3-2 3
Back to Top
