TM-9-2920-257-30-P
GENERATOR, ALTERNATING CURRENT, 200 AMPERES
TECHNICAL MANUAL; DIRECT SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS
MAY 1987
TM-9-2920-257-30-P - Page 50 of 111
TM 9-2920-257-30&P
(c) Place roller bearing tool (fig. F-1) on top of roller
bearing according to figure 3-11.
Press in bearing until it is
flush in housing with outer seal shoulder.
(5) Install rotor and ball bearing in drive end housing
assembly(fig.3-1) .
(a) Place anti-drive end housing (9), with interior of housing
facing up, on a vise with jaws opened approximately 4 inches.
(b) Place assembly spacer tool (fig. F-1) in anti-drive end
housing (9) so that it is centered around bearing bore.
NOTE
Assembly spacer tool installed in step (b) above will be removed in
step (g) below.
(c) Insert short end of shaft of rotor (14) in anti-drive end
housing (9).
(d) Place stator (19) and drive end housing assembly (21) over
rotor (14), and down into place on anti-drive end housing (9). Be
sure that stator laminations fit flush in pilot bore of anti-drive
end housing and that stator locator pin meshes with matching hole in
anti-drive end housing.
(e) Place entire assembly in arbor press with drive end
housing (21) facing up.
Support assembly on hub area of anti-drive
end housing (9) around shaft of rotor (14).
3-2 0
Back to Top
