TM-9-2920-257-30-P
GENERATOR, ALTERNATING CURRENT, 200 AMPERES
TECHNICAL MANUAL; DIRECT SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS
MAY 1987
TM-9-2920-257-30-P - Page 59 of 111
TM 9-2920-257-30&P
Section II.
PN N1205 AND N1206
3-4.
GENERAL INSTRUCTIONS
a.
The procedures discussed in this section cover complete disassembly of the generator.
b.
In cases where the generator does not require complete disassembly, disassemble only to the point required to
inspect, clean, and replace the damaged component.
3-5.
GENERATOR REPAIR INSTRUCTIONS
a.
Generator Cleaning Procedures.
(1.)
Clean exterior surfaces of generator as follows:
(a.) Clean exterior surface of generator with cloth (item 5, App B) dipped in dry cleaning solvent (item 2,
App B).
(b.) Dry thoroughly with compressed air or dry cloth (item 5, App B).
NOTE
Compressed air must not exceed 10 psig.
WARNING
Eye injury can occur if eye shields are not worn when using compressed air to
blow dirt or other particles off rotor slip rings.
Change 1
3-29
Back to Top
