TM-9-2990-205-34-P
TURBOSUPERCHARGER MODEL 5HDR
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
SEPTEMBER 2005
TM-9-2990-205-34-P - Page 39 of 128
TM 9--2990--205--34&P
0008 00--3
DISASSEMBLY OF THE TURBO INTO COMPONENT PARTS -- CONTINUED
0008 00
2. Removal of the Compressor Cover and Clamp.
a. Using metal scriber, scribe alignment marks on compressor cover (1) and bearing housing (2).
NOTE
If your turbo is a newer model, alignment marks will be cast into the housings, and the above
step will not be necessary. Take careful note of the matched alignment marks to ensure prop-
er reassembly.
b. Remove nut (3) from clamp (4). Loosen clamp and slide it down on bearing housing.
CAUTION
Use care when lifting compressor cover to prevent damage to compressor wheel.
c.
Remove compressor cover.
d. Remove clamp.
e. Remove and discard preformed packing (5) from bearing housing.
2
1
4
5
ALIGNMENT
MARKS
03i458m
3
Back to Top
