TM-9-2990-205-34-P
TURBOSUPERCHARGER MODEL 5HDR
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
SEPTEMBER 2005
TM-9-2990-205-34-P - Page 74 of 128
TM 9--2990--205--34&P
0012 00--12
ASSEMBLY AND OPERATIONAL TESTING -- CONTINUED
0012 00
j.
Install new preformed packing (13) on bearing housing.
k.
Install clamp (14) and slide it down on bearing housing.
l.
Install compressor cover (15). Align marks (16) scribed in housing flanges during disassembly. If your turbo is
a new/newer model, alignment marks will be cast into the flanges of the compressor cover and housing, and
the marks you noted during disassembly should be matched.
NOTE
If you cannot locate the alignment marks, or if you are otherwise unsure of the indexing of the
housings for your turbo, consult Table 3--1.
m. Place clamp (17) over compressor cover and bearing housing flanges, and install clamp nut (18).
n. Torque clamp nut to 110 to 130 lb--in (12.43 to 14.69 N
S
m).
03i499m
17
15
18
16
13
14
Back to Top
