TM-9-2990-205-34-P
TURBOSUPERCHARGER MODEL 5HDR
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
SEPTEMBER 2005
TM-9-2990-205-34-P - Page 69 of 128
TM 9--2990--205--34&P
0012 00--7
ASSEMBLY AND OPERATIONAL TESTING -- CONTINUED
0012 00
6. Installation of Flinger Sleeve Insert, Retaining Ring, Compressor Wheel Shims, and Compressor Wheel.
CAUTION
Use steady pressure but do not force flinger sleeve insert into bearing housing; metal seal
rings or flinger sleeve may fracture.
a. Center metal seal rings (1) on flinger sleeve (2) with gaps in rings 90 degrees apart.
b. Install flinger sleeve insert (3) in bearing housing below retaining ring groove. The arrow (4) stamped on the
top of the insert should be in line with the oil inlet port of the bearing housing.
c.
Install retaining ring (5).
d. Install compressor wheel shims (6).
03i493m
3
1
2
4
45
45
o
o
6
5
e. Place a 1--1/8 inch angular 12 point box wrench (7) in a vise. Position wrench to hold turbine wheel hub.
03i494m
7
Back to Top
