TM-9-6920-430-14
COOLANT RECHARGING UNIT, TRAINING GUIDED MISSILE SYSTEM M80 AND CHARGER, BATTERY PP-7309/T
TECHNICAL MANUAL; OPERATOR’S AND ORGANIZATIONAL DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL
AUGUST 1980
TM-9-6920-430-14 - Page 49 of 180
TM 9-6920-430-14
f.
Close chamber safety cover
securing safety cover to chamber.
and insert cover locking pin through lugs
WARNING
Be sure that the valve on the B&F adapter
installed in step g below is opened (turned
fully CCW) before installing on reservoir as-
sembly. Valve must remain in the open posi-
tion throughout the procedure. Failure to
comply could result in death or injury to
personnel.
g.
Insert fingers through slot in the chamber safety cover to hold reservoir
assembly and handtighten the B&F adapter to the B&F port.
h.
Remov e
from the end
NOTE
If outlet flexible hose is connected to GPU, proceed to
step
i.
protective cap from the GFU outlet fitting and the protective plug
of the GPU outlet flexible hose. Connect that end of the hose to
the GPU fitting. Attach the safety chain to the GPU eyebolt.
i.
Remove the protective cap from the other end of the outlet flexible hose.
Attach GPU flexible fill hose to B&F adapter.
j.
Attach safety chain at fill end of flexible fill hose around chamber mount-
ing bracket.
k.
Verify that safety chain at GPU end of flexible fill hose is attached to
GPU eyebolt on front of GPU.
1.
Close safety lid on GPU and secure both latches on rear of lid.
Change 5
2-20.3
Back to Top
