MWO-5-2350-262-35-3
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
MWO-5-2350-262-35-3 - Page 11 of 45
MWO 5-2350-262-35-3
2-5
SECTION V
REMOVAL PROCEDURES FOR SEMI-AUTOMATIC TRACK
ADJUSTER SYSTEM
1.
If applicable, remove track adjuster main wiring harness as follows:
a.
Remove rear floor plates per TM 5-2350-262-20-1, Rear Floor Plates Replacement.
b.
Remove track adjuster main wiring harness connector (Figure 2-1, 2) from suspension control electrical box
(1).
Figure 2-1.
Track Adjuster Main Wiring Harness.
c.
Remove ten track adjuster main wiring harness connectors (3) from ten coil connectors (4).
NOTE
Track adjuster main wiring harness is secured to other components as needed by electrical tie down
straps.
Cut/remove as required prior to removal.
d.
Set aside track adjuster main wiring harness (2) for disposition per Chapter 1, Section 1-8, step c.
2.
Remove track adjuster SPRUNG/UNSPRUNG tap wiring harness as follows:
a.
Move ejector forward per TM 5-2350-262-10, Folding the Dozer Blade.
2
4
1
3
2
Back to Top
