MWO-5-2350-262-35-3
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
MWO-5-2350-262-35-3 - Page 17 of 45
MWO 5-2350-262-35-3
2-11
6.
Remove track adjuster cylinders as follows:
a.
Relieve track tension per TM 5-2350-262-10, Track Tension Check/Adjustment.
WARNING
High pressure is present in the M9 hydraulic system.
Do not disconnect any hydraulic system
component unless hydraulic system pressure has been relieved.
Ensure each of the hydraulic
control levers is moved several times through all positions, and the hydraulic tank dipstick is
slowly loosened to relieve pressure.
Failure to comply may result in severe injury to
personnel.
Spilled hydraulic oil is very slippery.
Use caution when entering or working in bowl area.
Wipe up any spilled oil immediately.
Failure to comply may result in severe injury to
personnel.
Do not operate ejector when personnel are in bowl.
Do not work in bowl unless ejector lock is
engaged.
Failure to comply may result in severe injury to personnel.
CAUTION
Cover ports and hose or tube ends to prevent contamination of hydraulic oil.
Failure to comply may
result in damage to equipment.
NOTE
Have suitable container ready to catch oil.
b.
Remove two hoses (Figure 2-7, 2) from right side hydraulic track adjusting cylinder (1) and set aside for
disposition per Chapter 1, Section 1-8, step c.
Figure 2-7.
Track Adjusting Cylinder (1 of 3).
c.
Remove two hoses (4) from left side hydraulic track adjusting cylinder (3) and set aside for disposition per
Chapter 1, Section 1-8, step c.
NOTE
Section IV, step 6d applies to left cylinder, there is an additional clamp on left track adjusting cylinder.
Section IV steps 6e through 6g apply to both cylinders.
1
2
2
3
4
4
Back to Top
