MWO-5-2350-262-35-3
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
MWO-5-2350-262-35-3 - Page 12 of 45
MWO 5-2350-262-35-3
2
-
6
b.
Remove SPRUNG/UNSPRUNG switch tap wiring harness connector (Figure 2-2, 3) from track control wiring
harness connector (2).
Figure 2-2.
Track Adjuster SPRUNG/UNSPRUNG Switch Tap Wiring Harness.
NOTE
SPRUNG/UNSPRUNG switch tap wiring harness is secured to other components as needed by
electrical tie down straps.
Cut/remove as required prior to removal.
c.
Remove SPRUNG/UNSPRUNG switch tap wiring harness connectors (6 and 5) from SPRUNG/UNSPRUNG
switch connector (7) and wiring harness connector (8).
d.
Remove SPRUNG/UNSPRUNG switch tap wiring harness (3), by routing through hull (4) from driver’s
compartment (1) to SPRUNG/UNSPRUNG switch connector (7) and set aside for disposition per Chapter 1,
Section 1-8, step c.
e.
Install wiring harness connector (8) to SPRUNG/UNSPRUNG switch connector (7).
2
6
4
7
5
5
6
8
1
3
2
3
Back to Top
