MWO-5-2350-262-35-3
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
MWO-5-2350-262-35-3 - Page 29 of 45
MWO 5-2350-262-35-3
2-23
a.
Install elbow 4-6 C5OX-S (Figure 2-26, 1) to front cylinder port (2).
Figure 2-26.
Hydraulic Track Adjuster Cylinder (1 of 4).
b.
Install elbow 2062-6-6S (4) to rear cylinder port (3).
c.
If not installed, install lubrication fitting (Figure 2-27, 3) and plug (5) on fixed end of hydraulic track adjusting
cylinder 12466272 (8), so that lubrication fitting (3) faces forward and hydraulic ports (6 and 7) face upward.
Figure 2-27.
Hydraulic Track Adjuster Cylinder (2 of 4).
d.
Install plug (5) and lubrication fitting (4) on rod end of hydraulic track adjusting cylinder (8) so that lubrication
fitting (4) faces rearward.
NOTE
Coat threads of screw and nut with lubricating oil prior to installation.
Screw must be inserted from bottom when connecting fixed end of cylinder to hull.
e.
With cylinder ports (6 and 7) pointing up, connect fixed end of hydraulic track adjusting cylinder (8) to hull
mounting bracket (9) with pin (12), washer (11), screw (10), washer (2), and locknut (1) retained from Section
IV, step 6f.
NOTE
There is an additional clamp on left hydraulic track adjusting cylinder.
Coat threads of screw and nut with lubricating oil prior to installation.
1
4
5
5
7
4
6
3
11
10
2
8
9
1
2
3
12
Back to Top
