MWO-5-2350-262-35-3
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
MWO-5-2350-262-35-3 - Page 32 of 45
MWO 5-2350-262-35-3
2
-
26
b.
Route headlight wiring harness 12491606 (Figure 2-32, 12) through openings in top of four braces (10) inside
apron back wall starting from left headlight to right headlight and fix with tie straps MS3367-1-9.
Figure 2-32.
Headlight Wiring Harness.
c.
Install four apron wiring harness leads (1) in apron (2) to headlight harness leads (12), matching circuit
numbers on leads.
d.
Install two terminals 8338564 (8), sleeves 8338562 (7), and shells 8338561 (6) to two six inch (152.40 mm)
cables M13486/1-5 (5).
e.
Install two butt splices 8-34071-1 (3) to cables (5) and apron mercury cables (9) by sliding three inch (76.20
mm) insulation sleevings M23053/1-101-0 (4) over butt splices and heat shrink.
f.
Install two apron wiring harness leads (11) #514 and #515 to two mercury switch leads (8).
CAUTION
Do not turn or twist headlight during installation.
Turning or twisting headlight can damage headlight
wiring harness.
NOTE
Installation procedures for the headlight are the same for both sides of the vehicle.
The right side is
shown here.
10
2
1
3
7
6
5
4
8
9
11
12
Back to Top
