MWO-5-2350-262-35-3
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
MWO-5-2350-262-35-3 - Page 35 of 45
MWO 5-2350-262-35-3
2-29
WARNING
Steel blade assembly weighs 1165 lbs (528.435 kg).
Use appropriate lifting device.
Failure to
comply may result in severe injury to personnel.
Personnel must stand clear during lifting operations.
Failure to comply may result in severe
injury to personnel.
n.
Use appropriate lifting device to install blade (Figure 2-36, 1) retained from Section III, step 1, on apron (2).
Make sure that holes on blade dogs line up with holes on apron actuator (4).
Figure 2-36.
Blade.
NOTE
Old apron had four pins, new apron has two.
o.
Attach blade (1) to apron (2) with two pins (3).
5.
Remove bolts and nut sleeves. Slide track and blade control box 12491619 (Figure 2-37, 1) behind instrument
panel (5) and install two screws (4) and flat washers (3), retained from Section IV, step 4a, on instrument panel.
And use tow nuts MS35649-2254 in place of nut sleeves 3D5074.
Figure 2-37.
Track and Blade Control Box.
6.
Install manifold harness connector 12491622 (2) on track and blade control box (1).
7.
Install control box power harness connector 12491618 (7) on track and blade control box (1).
3
4
3
7
2
3
1
5
6
4
2
1
4
Back to Top
