MWO-9-2300-378-34-2
TANK, COMBAT FULL-TRACKED
MODIFICATION WORK ORDER
JUNE 1984
MWO-9-2300-378-34-2 - Page 29 of 92
MW09-2300-378-34-2
(8) Drain fuel/water separator (refer to appropriate vehicle TM)
(9) Disconnect fuel outlet hose from bottom of fuel/water separator existing outlet
elbow 10935536 (figure 17, view A).
(10) Remove and discard fuel/water separator existing outlet elbow 10935536
(figure 17, view A).
(11) Apply teflon tape on tee AN825-8 and install tee in fuel/water separator outlet
port (figure 17, view B).
(12) Connect fuel outlet hose to tee AN825-8 (figure 17, view B).
(13) Connect hose assembly MS28741-8-0194 to tee AN825-8 and to manual shut-off
valve (figure 17, view B).
(14) position tube assembly 12275811 under electrical harnesses and along left engine
access covers (figure 18).
(15) connect tube assembly 12275811 to manual shut-off valve 45° elbow and to
shroud elbow (figure 18). A 11/16-inch open-end box wrench will be required to tighten tube
assembly to shroud elbow.
(16) Remove and retain screws and lockwashers (from positions, 2 and 6, figure 18)
securing engine access covers.
(17) Install clamps MS21333-111 on tube assembly at positions 2 and 6 (figure 18).
Secure clamps and engine access cover with screws and lockwashers removed in step 16.
27
Back to Top
